MRV Communications AE092FCAKA Especificaciones descargar pdf (Pagina 30)

Installing the LX Series

451-0308

If the LX Series does not detect an error, the unit begins loading software

from the internal flash. Once loaded, the LX Series resumes normal

operations.

Configuring the LX Unit for the First Time

You can choose from four options to configure the unit for the first time:

• First Time Configuration Utility - The first time an LX unit boots

up at default parameters, you are presented with the option to run the

Initial Connectivity setup. Enter y and press <Enter>. Refer to “First

Time Quick Configuration” on page 30 for further details.

• Assign the IP Address via the Network - Refer to “Assigning an IP

Address via the Network” on page 33 for further details. Use this

option if your network is using DHCP, BOOTP, or RARP.

• Creating and Loading a Default Configuration File - Refer to

“Applying Default Configurations to Other Units” in the LX-Series

Configuration Guide.

• Configuring the LX Manually via the CLI - Refer to “Upgrading

Software with the ppciboot Main Menu” in the LX-Series Configuration

Guide.

First Time Quick Configuration

NOTE: The first time quick configuration runs only on the DIAG port (port 0)

on all models when booting from default parameters. The DIAG port

(port 0) of the LX-4008, LX-4016, and LX-4032 is on the rear of the

unit. The LX-4048 DIAG port (port 0) is on the front of the unit.

NOTE: Display problems may occur during bootup when you attach a

VT420 terminal to the DIAG port (port 0) and the VT420 display

setup is configured to Smooth-2 Scroll. To avoid this, change

the VT420 scroll setting to Jump Scroll.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 68 69

Sin comentarios

MRV Communications AE092FCAKA Especificaciones Pagina 30