MRV Communications AE092FCAKA Especificaciones descargar pdf (Pagina 31)

451-0308

Installing the LX Series

Use the following procedure to configure your LX unit for the first time.

1. Plug in the terminal at the DIAG port (port 0 - port values are 9600

bps, eight data bits, one stop bit, no parity, and Xon/Xoff flow control).

The Main Menu appears.

2. Press b to boot the LX unit. The setup takes a minute or two. The The

unit has loaded to factory defaults, would you like to

run Initial Connectivity Setup? y/n message appears.

3. Press y (yes) and press <Enter>. The Superuser Password prompt

appears.

4. Enter password system. The Quick Configuration menu appears:

5. Press the number corresponding to the parameter you want to set.

6. Enter the appropriate information and press <Enter> to return to the

Quick Configuration menu. Once you enter a parameter value, a data

entry line specific to that parameter appears on the Quick Configuration

menu.

7. Continue in this way through the menu, configuring as many parameters

as you want. You are not required to configure all parameters.

Quick Configuration menu

1 Unit IP address

2 Subnet mask

3 Default Gateway

4 Domain Name Server

5 Domain Name Suffix

6 Superuser Password

7 Exit and Save

Enter your choice:

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 68 69

Sin comentarios

MRV Communications AE092FCAKA Especificaciones Pagina 31