MRV Communications LX-4000 Series Información técnica descargar pdf (Pagina 639)

100

101

L-10 Advanced LXPORTD Application

LX Series Configuration Guide

Config:0>>port async 1-32 no authentication

outbound

Config:0>>port async 1-32 no autohangup

Config:0>>port async 1-32 no telnet negotiations

Config:0>>port async 1-32 speed 57600

Config:0>>port async 1-32 flowcontrol cts

Config:0>>port async 1-32 parity none

Config:0>>port async 1-32 character 8

Config:0>>interface 1 broadcast group 1 master port

tcp 1024 - this is the TCP port Lxportd will connect to at

start-up time.

Config:0>>interface 1 broadcast group 1 mode char -

pass characters along as the LX receives them.

Config:0>>interface 1 broadcast group 1 virtual

authentication radius enable - The security method will

be RADIUS. It is assumed that RADIUS has already been set

up on the LX and is functioning properly.

Config:0>>interface 1 broadcast group 1 slave port

async 1-32 - all 32 serial ports will be slaves. Ports 1-31

will have TV monitors attached. Port 32 will have a crossover

cable attached that will go to port 1 of the next LX in line (see

the diagram above and the LX32 port slave unit #1

configuration below).

Config:0>>interface 1 broadcast group 1 enabled -

this enables the broadcast group.

LX 32 port slave units #1, #2 and #3 configuration consist of

one broadcast master async port (port 1), with serial ports 2-32

acting as broadcast slaves. All three LX slave units #1, #2, and

#3 should be configured as follows (exceptions are noted

below).

Enter the following commands:

Config:0>>interface 1broadcast group 1 master port

async 1

1 2 ... 634 635 636 637 638 639 640 641 642 643 644 ... 691 692

Comentarios a estos manuales

Sin comentarios

MRV Communications LX-4000 Series Información técnica Pagina 639

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores MRV Communications LX-4000 Series